Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Table of Contents

Introduction

English

Multi Tools provide the ability to run multiple process tool plugins in a single tool bubble of a process design, with the option of multi-threading support.

This greatly reduces the effort and time needed to achieve a multiple tools parallel execution process design.

Multi Tools Properties

Enable this option to instruct Joget to wait for all plugins in this tool to complete execution, before proceeding to the next step in a process.

Applicable only when Run Tools In Multithread option is checked
NameDescriptionScreens (Click to view)
Tool

Select any process tool plugin here, and add more rows to configure even more plugins.

After selecting your desired tool(s), you can configure them on subsequent configuration tab(s).

By checking this option configuring tool(s) without enabling Run Tools In Multithread, all plugin(s) will run in a sequential manner.

Image Removed

Figure 1: Multi Tools Properties

Run Tools In Multithread

Enable this option to run each and every configured plugins in separate threads.

This may significantly increase performance for process instance management in cases of plugins with heavy processing.

By checking this option without enabling Wait for all Threads to Finish, Joget will proceed to the next step in a process regardless of completion of process tool plugins.

Note

Do take consideration of form data integrity & consider the use of Wait for All Threads to Finish option.

Wait for all Threads to Finish
Run Mode
  • Run tools sequentially in current thread: Finish the first tool then start the second tool.
  • Run tools concurrently in multiple threads: each tool start in a single thread.
  • Run tools sequentially in a new single thread: one thread to execute all tools.

Note that option 2 above is only possible if the second tool is *not* dependant on the first tool completing its job first (both tools should be independent of each other).

Comment

General notes.

Image Added

Figure 1: Multi Tools Properties

Tips

Recommended to use the Process Multi-tool plugin to reduce the need to constantly modify the process design, which forces a process record migration to a new version. When designing a process flow, add just one tool box to one activity box, even though the design requires 5 tool boxes. The 5 tools go into the single process Multi-Tool plugin configuration. Another advantage is you can run the tools in multithread for some performance gain.